nimetzrj
Well-known member
I am in the process of drawing up my plans for a Pembroke table that I have taken pictures and measurements of. In going over the measurements and photos I noticed that the corner beads on the legs are tapered from 1/4" at the top of the leg to 1/8" at the bottom. Attached is a photo of the table.
I want to accomplish this bead with hand tools only. I was thinking of marking the top of the leg 1/4" and the bottom at 1/8", then secure a scrap piece of wood on the marks. Using a 1/4" scratch stock follow the scrap piece of wood to produce the tapered bead. Is there any other ways of accomplishing this task?
Thank you
I want to accomplish this bead with hand tools only. I was thinking of marking the top of the leg 1/4" and the bottom at 1/8", then secure a scrap piece of wood on the marks. Using a 1/4" scratch stock follow the scrap piece of wood to produce the tapered bead. Is there any other ways of accomplishing this task?
Thank you