wallysandcrab
Well-known member
I will soon be installing chippendale pulls/backplates in an oxbow chest. The pulls will be installed on a curved surface. In order to get the flanges of the bail posts to seat cleanly the posts would have to be bored square to the face...i.e. the holes and the posts would be non-parallel and would point toward each other slightly. This kinda throws off the way the bail sits in the post holes.
That's how you do it, right? And then bend the bail to accomodate?
Thanks
JD
That's how you do it, right? And then bend the bail to accomodate?
Thanks
JD