ttalma
Well-known member
I just purchased a set of hollows and rounds with skewed blades. The bodies are in good shape but the blades are a little rough with some knicks on the thier edge and some surface rust.
I know how to clean the faces and remove the rust. But for the most part I will have to re grind thier edge, most about 1/16 and one about 1/8. What is the easiest way to do this?
I usually touch up the edges by hand and keep them sharp, so that It's never alot of work. If it were 1 or two blades I would do it this way, but I will have to do 12.
I recall seeing some sort of setup for a lathe, but can't rember where, or even if I am remebering correctly.
So basically what is the best way to regrind the edges? I don't mind doing the final honing by hand but I'd like a little faster way to do the main grinding.
I know how to clean the faces and remove the rust. But for the most part I will have to re grind thier edge, most about 1/16 and one about 1/8. What is the easiest way to do this?
I usually touch up the edges by hand and keep them sharp, so that It's never alot of work. If it were 1 or two blades I would do it this way, but I will have to do 12.
I recall seeing some sort of setup for a lathe, but can't rember where, or even if I am remebering correctly.
So basically what is the best way to regrind the edges? I don't mind doing the final honing by hand but I'd like a little faster way to do the main grinding.