Progress on two projects

turner

Well-known member
First is a Townsend Knee Hole Bureau. Both concave shells are finished and I'm working on 3 convex shells. I am going to pick the best two for the bureau.
Second is a walnut ball & claw tilt and turn tea table. I'm thinking the legs may be too massive (thick) for the size of the pedestal.
What do you think?


David Turner
North Raleigh
 

Attachments

  • DSCN0720.JPG
    DSCN0720.JPG
    673.2 KB · Views: 35
  • DSCN0721.JPG
    DSCN0721.JPG
    720.5 KB · Views: 30
  • DSCN0722.JPG
    DSCN0722.JPG
    706 KB · Views: 30
I wish everyone would post stuff like this. There seems to be so little traffic at the Forum lately, and I've always enjoyed the taking a break during work to check to see if anything has been posted.


Tom
 
Pedestal/Legs look good to me David, but I am no expert. You could check out these Member-Submitted plans on the website (Member only side) to see how your measurements compare:


[/size]
    • Jeff Justis Globe Stand (Article in past APF Journal with photos)[/l][/l]
      • Scott Calkins Pie Crust Tea Table

      • [/size]

        Dale
        [/size]
 
Back
Top