I am drawing up plans for a small but charming late 18th century urn table / stand in mahogany.....
I am hoping someone may be able to advise on appropriate technique for the mortice and tenon joint. The legs are tapered and angled by about 4 degrees and although there are a few ways one can tackle the M&T I was hoping to find out what would be the most common way in the period, or perhaps there was no common way....
I have attached an image of the general design.
I am hoping someone may be able to advise on appropriate technique for the mortice and tenon joint. The legs are tapered and angled by about 4 degrees and although there are a few ways one can tackle the M&T I was hoping to find out what would be the most common way in the period, or perhaps there was no common way....
I have attached an image of the general design.