R
rococojo
Guest
Hi, following a resent post on this subject, I enclose a diagram of the construction method used; I think it possibly some might have unread the first post.
The early method used was this? One brace is placed at the corner of each leg joint; to equalize the strain generated by the seat webbing, let me explain further? Lets take the front rail, leg, and the connecting side rail, as a example, a brace, say 5" long x 1"x1", this is placed equally across the corner, then marked with a pencil line, a housing joint is then made 1/4" deep in to the front rail & side rail.
The chair is then glued up.
After cleaning of the excess glue from all the joints, the proposed brace is placed over the pre-cut housing joints and marked and cut to the corresponding housing joint, (I like to wedge this cut on brace) this is then just glued in place. When dry, and the webbing are stretched to the desired tension.
This Conclusion can now be made. No pressure is on the leg mortise & tenon? But on each rail housing only, the front pressure is transferred through to the side rail, and visa versa. So no other fixing (screw or nail) is required, just a good tight fit, and glue.
The early method used was this? One brace is placed at the corner of each leg joint; to equalize the strain generated by the seat webbing, let me explain further? Lets take the front rail, leg, and the connecting side rail, as a example, a brace, say 5" long x 1"x1", this is placed equally across the corner, then marked with a pencil line, a housing joint is then made 1/4" deep in to the front rail & side rail.
The chair is then glued up.
After cleaning of the excess glue from all the joints, the proposed brace is placed over the pre-cut housing joints and marked and cut to the corresponding housing joint, (I like to wedge this cut on brace) this is then just glued in place. When dry, and the webbing are stretched to the desired tension.
This Conclusion can now be made. No pressure is on the leg mortise & tenon? But on each rail housing only, the front pressure is transferred through to the side rail, and visa versa. So no other fixing (screw or nail) is required, just a good tight fit, and glue.