Search results

There is a new woodworking school in Arizona.  The Southwest Center for Craftsmanship has been started in Arizona.  It is the only woodworking school in Arizona that offers a comprehensive offering of woodworking classes. We have well known instructors that teach various classes.  Visit our...

I recently worked on an antique that was made in around the early 1800's.  It had wooden threads on some parts.  The threads were in good shape.  Does anyone know how they made the threads back then? Raul

I have access to some Nicaraguan rosewood.  It was cut about 30 to 35 years ago.  various sizes of between 8" to 12" wide 16/4 and 8 to 10 feet long.  Un fortunately this was sitting outside un protected for the past 26 to 30 years and has developed deep checks all over the surface.  Some of...

I am going to make a four poster bed with tapered and fluted posts.  The taper starts at 4 1/2 inches and tapers down to 2 1/2 inches.  does anyone know of the technique to make the flutes?  The flutes would be wider at the bottom than the top and I suspect the depth of cut would be about the...

I have a valuable antique with damage in the center of the field.  The damage is a scrape in the silvering approx 2 square inches.  Does anyone know how to repair this type of damage, or does anyone know of a place that performs this tupe of repair? Thank you Raul

I have a table to make and the pedestal is an "onion bulb shape" does anyone have any suggestions on the construction of this shape? Thanks Raul